UNIX PRINTING 1 - 4
3
Configure the /etc/printcap file on each host computer to
specify the local print queue, the print server name (also called
remote machine or rm), and the print server service name (also
called remote printer, remote queue, or rp), and the spool
directory.
An example of a typical printcap file:
laser1|Printer on Floor 1:\
:lp=:\
:rm=BRN_310107:\
:rp=TEXT_P1:\
:sd=/usr/spool/lpd/laser1:
This step applies to the majority of UNIX systems, including
Linux, Sun OS (but not Solaris 2.xx), Silicon Graphics (lpr/lpd
option required), DEC ULTRIX, DEC OSF/1, and Digital
UNIX. SCO UNIX users should follow these steps, but should
also refer to the SCO UNIX Configuration section. Users of
RS/6000 AIX, HP-UX, Sun Solaris 2.xx, and other systems
that do not use the printcap file should skip to step 4. SCO
user's should also skip to step 4 (SCO uses the printcap file,
but this file is automatically configured via the rlpconf
command).
Make sure this information is added to the end of the printcap
file. Also make sure that the last character in the printcap file
is a colon ":".
This will create a queue named laser1 on the host computer
that communicates to a Brother print server with a node
name (rm) of BRN_310107 and a service name (rp) of
TEXT_P1 printing text files to a Brother printer through spool
directory /usr/spool/lpd/laser1. If you are printing
binary graphics files, you would use the service BINARY_P1
instead of TEXT_P1.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
