12
Setting Up Your Printer
Do NOT connect the interface cable.
Connecting the interface cable is
done when installing the driver.
1 Remove all the packing tape.
2 Open the top cover.
Do not touch any parts inside the
printer.
3 Take the toner cartridge out of the box and
rock it 7 to 8 times.
4 Place the toner cartridge on a flat surface
and pull the seal out horizontally.
5 Hold the toner cartridge by the grip and
insert it into the slot inside the printer.
6 Close the top cover securely.
1 Install the Toner Cartridge
Top cover
â– When pulling out the seal, pull it out
horizontally. The tape might break if it is
pulled out diagonally.
â– After the seal has been pulled out, do not
shake or bump the toner cartridge.
Make sure that the toner cartridge is firmly
set.
Step 1
Seal
Toner cartridge
To Next Page
Loading...
