Brother HL-8050N - For Administrators; Setting Your IP Address, Subnet Mask and Gateway (Using the Control Panel)

37
■ For Administrators
1 Press until
NETWORK= is
displayed.
2 Press .
3 Press again.
4 Press until IP
ADDRESS= is displayed.
5 Press .
6 Enter the IP address for
this printer using
or .
(for example 192)
7 Press and move
the cursor to the next
value.
8 Repeat Steps 6 and 7
to finish setting the IP
address.
9 Press to complete
the IP address.
An asterisk mark (*)
appears on the LCD
.
0 Press until
SUBNET MASK= is
displayed.
A Press .
B Set your subnet mask in
the same way as the IP
address.
An asterisk mark (*)
appears on the LCD.
C Press until
GATEWAY= is
displayed.
D Press .
E Set your gateway
address in the same way
as the IP address.
An asterisk mark (*)
appears on the LCD.
F Press to put the
printer back into its
READY.
Setting your IP Address, Subnet Mask and
Gateway (Using the Control panel)
Your printer is configured to receive an IP address, Subnet mask and Gateway address from a DHCP
server. If you do not use a DHCP server follow the steps below.
-MENU-
NETWORK
NETWORK
TCP/IP
TCP/IP
IP ADDRESS=
IP ADDRESS=
0. 0. 0. 0*
IP ADDRESS=
192. 0
. 0. 0
IP ADDRESS=
192. 0. 0. 0
IP ADDRESS=
192.168.001.100
IP ADDRESS=
192.168.001.100*
TCP/IP
SUBNET MASK=
SUBNET MASK=
0. 0. 0. 0*
SUBNET MASK=
255.255.255.000*
TCP/IP
GATEWAY=
GATEWAY=
0. 0. 0. 0*
GATEWAY=
192.168.001.254*
READY
Setting Up
Your Printer
Windows
®
USB
Windows
®
Parallel
Windows
®
Network
Macintosh
®
USB
Macintosh
®
Network
For
Administrators
Installing the Driver