Brother HL-S7000DN - For Wired Network Interface Cable Users

15
Macintosh
Wired Network
Windows
®
Macintosh
Wired Network
For Wired Network Interface Cable Users
10
Before you install
a Make sure your machine is connected to the
power and your Macintosh is ON. You must be
logged on with Administrator rights.
b Remove the protective cap from the Ethernet
port marked with a symbol.
c Connect the network interface cable to the
Ethernet port, and then connect it to a free port
on your hub.
d Make sure your machine’s power switch is on.
11
Install the printer driver
a Put the installation CD-ROM into your
CD-ROM drive.
b Double-click the Start Here OSX icon.
c Choose Wired Network Connection
(Ethernet) and then click Next. Follow the
on-screen instructions.
d Choose your machine from the list, and then
click OK.
Note
• For users of Mac OS X 10.5.7 or lower,
upgrade to Mac OS X 10.5.8 - 10.7.x. (For the
latest drivers and information for the Mac OS X
you are using, visit
http://solutions.brother.com/
.)
• If you want to add the PS driver (BR-Script3
printer driver), please go to the Brother
Solutions Center at
http://solutions.brother.com/
and visit FAQ’s on
your model page for instructions.
Note
It may take a few minutes for the installation to
complete.
Note
• If there is more than one of the same model
connected on your network, the MAC Address
(Ethernet Address) will be displayed after the
model name.
• You can find your machine’s MAC Address
(Ethernet Address) and IP Address by printing
out the Printer Settings Page. See Print the
Printer Settings Page on page 32.