Brother LK3-B430E MARK II - 4-7. Feed mechanism (1)

LK3-B430E Mark II
16
4. DISASSEMBLY
q
i
t
w
y
r
e
!2
!3
u
!0
!1
!3
!2
o
4-7. Feed mechanism (1)
1. With the machine head tilted, loosen the set screw of the set screw collar q, and remove the latter.
2. Return the machine to its original position.
3. Loosen the set screw w, and remove the tack width lever shaft t and the washer r from above.
* When the tack width lever shaft t is not removed, remove the retaining ring e and the washer r.
4. Remove the Y feed lever i by lifting it in the direction of the arrow.
* Remember to remove the washer r under the Y feed lever i.
5. Remove the screw y, and home position sensor Y u.
6. Remove the X feed lever o by lifting it in the direction of the arrow.
7. Remove the screw !0 and home position sensor X !1.
8. Remove the screw !2, the cord support !3, and home position sensors Y u and X !1.