Brother LK3-B430E MARK II - 10-7. Checking the input sensor and DIP switch input

LK3-B430E Mark II
10. ELECTRIC MECHANISM
72
SELECT
PROGRAM NO.
RESET
COUNTER
X
-
SCALE
Y
-
SCALE
SPEED
P
TEST
BOBBIN.WIND
P4P3
P1 P2
B430E Mark Series
POWER
q
e
w
t
r
10-7. Checking the input sensor and DIP switch input
1. When the X-SCALE indicator q is illuminated and the RESET switch e is pressed while the TEST switch w
is being pressed, the state of the X home position signal will appear on the display window r.
• When sensor is ON • When sensor is OFF
2. Each time the SELECT switch t is pressed, a different indicator will illuminate and the operating condition
for the corresponding item will appear on the display window r.
• When X-SCALE indicator is illuminated............X home position sensor (ON when home position detected)
• When Y-SCALE indicator is illuminated............Y home position sensor (ON when home position detected)
• When SPEED indicator is illuminated ...............Synchronizer (*1)
• When COUNTER indicator is illuminated .........Presser sensor (ON when presser is lowered)
* 1) The synchronizer display simultaneously displays the needle up signal (3rd digit), the 24-section signal
(2nd digit) and the needle down signal (1st digit).
[ H L L ] “H” when the sensor is on, and “L” when the sensor is off
Needle down signal
24-section signal
Needle up signal
If the DIP switches at the side of the operation panel are changed at this time, the number of the DIP switch
which was changed will be displayed in the 4th digit position of the disply window r for about one second.
NOTE:
The DIP switch can be changed at this time without turning off the power so that you can check the DIP
switch input. However, you should normally always turn off the power when changing DIP switch set-
tings.
3. Press the TEST switch w again to return the display to the normal condition.