E
Eric RomeroJul 27, 2025
What to do if the needle is bent on my Brother Sewing Machine?
- LlewispaigeJul 27, 2025
If the needle is bent, or the needle tip is broken or blocked on your Brother Sewing Machine, replace the needle.
To Next PageTo Next PageWhat to do if the needle is bent on my Brother Sewing Machine?
If the needle is bent, or the needle tip is broken or blocked on your Brother Sewing Machine, replace the needle.
What to do if the needle is touching the needle plate on my Brother DB2-B737 Mark III Sewing Machine?
If the needle is touching the needle plate on your Brother Sewing Machine, re-seat the needle plate.
How much thread should be coming out of the needle hole on my Brother DB2-B737 Mark III?
When threading the upper thread on your Brother Sewing Machine, ensure that approximately 50 mm of thread should be coming out of the needle hole.
What to do if the knives are blunt on my Brother Sewing Machine?
If the movable and fixed knives are blunt on your Brother Sewing Machine, replace the fixed and movable knives.
What to do if the thread wiper is touching the needle on my Brother Sewing Machine?
If the thread wiper is touching the needle on your Brother Sewing Machine, adjust the needle up stop position.
General| Stitch Type | Lockstitch |
|---|---|
| Max Stitch Length | 5 mm |
| Needle Bar Stroke | 30.7 mm |
| Presser Foot Lift | By hand: 5.5 mm, By knee: 13 mm |
| Needle | DB x 1 |
SINGLE-NEEDLE STRAIGHT LOCK STITCHER WITH THREAD TRIMMER
Explains safety symbols and terms used in the manual and on the machine.
Provides important safety advice regarding installation and general operation.
Details the process of installing the machine head onto the work table.
Describes how to install the knee lifter assembly.
Explains how to adjust the knee lifter for proper operation.
Details how to install the drive belt onto the pulleys.
Explains how to correctly connect the ground wire for safety.
Describes the process of installing the bobbin winder unit.
Details on synchronizing the needle and rotary hook for proper operation.
Guide on adjusting upper and lower thread tension for a correct seam.
