Brother MFC-465CN - Print Quality Check

Setting Up the Machine
10
STEP 1
6 Print quality check
1 After the cleaning cycle is finished, the LCD
shows:
Set Paper and Press
Start
2 Make sure A4, Letter or Legal size paper is
loaded in the paper tray.
Press Colour Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
3 Check the quality of the four colour blocks on
the sheet.
(black/yellow/cyan/magenta)
Note
Avoid touching the printed surface of the paper
immediately after printing, the surface may not be
completely dry and may stain your fingers.
4 The LCD shows:
Is Quality OK?
Yes i Press 1
No i Press 2
 If all lines are clear and visible, press 1
(Yes) on the dial pad to finish the quality
check.
 If you can see missing short lines, press 2
(No) on the dial pad and go to step 5.
5 The LCD asks you if the print quality is OK for
black and colour. Press 1 (Yes) or 2 (No) on the
dial pad.
Black OK?
Yes i Press 1
No i Press 2
Color OK?
Yes i Press 1
No i Press 2
After pressing 1 (Yes) or 2 (No) for both black
and colour, the LCD shows:
Start Cleaning?
Yes i Press 1
No i Press 2
6 Press 1 (Yes), the machine will then start
cleaning the colours.
7 After cleaning is finished, press Colour Start.
The machine starts printing the Print Quality
Check Sheet again and goes back to step 3.
OK Poor