Setting Up the Machine
7
Note
If you are sharing one telephone line with an
external telephone answering machine, connect it
as shown below.
Set the receive mode to ‘External TAD’, if
you have an external answering machine.
For details, see Connecting an external TAD
(telephone answering device) in Chapter 7 of
the User’s Guide.
4 Set Your Country
(For Australia / New Zealand
Customer Only)
You must set your country so that the machine works
correctly on local telecommunication lines in each
country.
1 Check that the power is turned on by
connecting the power cord.
2 Press a or b to select the country
(Australia or Newzealand).
Set Country
Australia
Newzealand
Press OK when the LCD shows your country.
3 The LCD prompts you to make sure of the
country again.
Set Country
Australia
Yes
No
4 If the LCD shows the correct country, press OK
to go to the next step.
Or press Clear/Back to go back to Step 2 to
select the country again.
5 After the LCD shows Accepted for two
seconds, it shows Please Wait.
(Example for Australia)
To Next Page
Loading...
