Brother MFC-5490CN - 5 Sending a Fax; Entering Fax Mode; Faxing from the ADF; Faxing from the Scanner Glass

28
5
Entering Fax mode 5
Press (Fax) to enter Fax mode.
Faxing from the ADF 5
a Make sure you are in Fax mode .
b Place the document face up in the ADF.
(See Using the ADF on page 17.)
c Enter the fax number using the dial pad,
One Touch, Speed Dial or Search.
d Press Mono Start or Colour Start.
The machine starts scanning the
document.
Note
• To cancel, press Stop/Exit.
• If you send a mono fax when the memory
is full it will be sent in real time.
Faxing from the scanner glass5
You can use the scanner glass to fax pages
of a book one at a time. The documents can
be up to Letter or A4 size.
You cannot send colour faxes with multiple
pages.
Note
Since you can only scan one page at a
time, it is easier to use the ADF if you are
sending a multiple page document.
a Make sure you are in Fax mode .
b Load your document on the scanner
glass.
c Enter the fax number using the dial pad,
One Touch, Speed Dial or Search.
d Press Mono Start or Colour Start.
 If you press Mono Start, the
machine starts scanning the first
page. Go to step e.
 If you press Colour Start, the
machine starts sending the
document.
e Do one of the following:
 To send a single page, press 2 to
choose No (or press Mono Start
again).
The machine starts sending the
document.
 To send more than one page,
press 1 to choose Yes and go to
step f.
f Place the next page on the scanner
glass.
Press OK.
The machine starts scanning the page.
(Repeat step e and step f for each
additional page.)
Sending a Fax 5