Brother MFC-5890CN - Tray Use in Copy Mode (MFC-6490 CW Only); Tray Use in Fax Mode (MFC-6490 CW Only)

Chapter 3
28
Tray use in Copy mode
(MFC-6490CW only) 3
You can change the default tray the machine
will use for printing copies.
To change the default setting follow the
instructions below:
a Press Menu.
b Press a or b to choose
General Setup.
Press OK.
c Press a or b to choose Tray Setting.
Press OK.
d Press a or b to choose
Tray Use:Copy.
e Press d or c to choose Tray#1 or
Tray#2.
Press OK.
f Press Stop/Exit.
Note
You can change the paper size and tray
selection temporarily for the next copy.
(See Paper Size on page 99 and Tray
Select (MFC-6490CW only) on page 99.)
Tray use in Fax mode
(MFC-6490CW only) 3
You can change the default tray the machine
will use for printing received faxes.
Auto Select will allow your machine to
take paper from Tray #1 first, or from Tray #2
if:
 Tray #1 is out of paper.
 Tray #2 is set to a different paper size that
is more suitable for the received faxes.
 Both trays are using the same size paper
and Tray #1 is not set to use plain paper.
a Press Menu.
b Press a or b to choose
General Setup.
Press OK.
c Press a or b to choose Tray Setting.
Press OK.
d Press a or b to choose Tray Use:Fax.
e Press d or c to choose Tray#1,
Tray#2 or Auto Select.
Press OK.
f Press Stop/Exit.