Brother MFC-7440N

For Network Users
27
3 Web Based Management
(web browser)
The Brother print server is equipped with a web server
that allows you to monitor its status or change some
of its configuration settings, using HTTP (Hyper Text
Transfer Protocol).
Note
• The User Name is ‘admin’ and the default
password is ‘access’. You can use a web
browser to change this password.
• We recommend Microsoft Internet Explorer
6.0
®
(or higher) or Firefox
®
1.0 (or higher) for
Windows
®
and Safari™ 1.0 for Macintosh
®
.
Please also make sure that JavaScript and
cookies are always enabled in whichever
browser you use. We recommend you upgrade
to Safari™ 1.2 or higher to enable JavaScript.
To use a web browser, you will need to know
the IP address of the print server.
1 Open your browser.
2 Type http:// printer_ip_address /into your
browser (Where “printer_ip_address” is the IP
address of the printer or the print server name).
 For example http://192.168.1.2/
See Chapter 2 of the Network User's Guide.
4 Restoring the network
settings to factory default
To restore all network settings of the internal
Print/Scan server to factory default, please follow the
steps below.
1 Make sure the machine is not in use, then
disconnect all the cables from the machine
(except power cable).
2 Press Menu, 4, 0.
3 Press 1 to select Reset.
4 Press 1 to select Yes.
5 The machine will restart. Re-connect cables
once this is complete.
5 Print the Network
Configuration List
You can print the Network Configuration List to
confirm the current network settings. To print the
Network Configuration List:
1 Make sure that the front cover is closed and the
power cord is plugged in.
2 Turn on the machine and wait until the machine
is in the Ready state.
3 Press Reports and or to select
Network Configuration. Press OK. The
machine will print the current network settings.