This
equipment has been tested and
found
to comply
with
the limits for a
Class
B
digital
device,
pursuant to Part 15 of the FCC
Rules.
These
limits are designed to provide reasonable protection
against
harmful Inferference In a residential installation.
This
equipment generates,
uses,
and can
radiate radio frequency energy and, if not installed and used In accordance
with
the instructions,
may
cause
harmful Interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause
harmful
interference to radio or television reception, which can be determined by
turning
the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following
measures:
. „, . „ ^,
• Reorient or relocate the receiving antenna. .
•
Increase
the separation between the equipment and receiver. ' •' •
• Connect the equipment
into
an
outlet
on a circuit different
from
that to which the receiver Is
connected.
•
Call
the dealer or an experienced radio/TV technician for help. .
iVjjV'.
j
• {Wireless network models only)
This
transmitter must not be co-located or operated in conjunction
with
any other antenna or
transmitter.
O Important
• Changes or modifications not expressly approved by Brother Industries, Ltd. could void the
user's
authority to operate the equipment.
• A shielded interface cable should be used to ensure compliance
with
the limits for a
Class
B
digital
device.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
