Brother MFC-J200 - Using Remote Codes; Remote Deactivation Code

Chapter 6
34
Using remote codes 6
Remote Activation Code 6
If you answer a fax call on an extension or
external telephone, you can tell your machine
to receive it by dialling the Remote Activation
Code l 51. Wait for the chirping sounds and
then replace the handset. (See Fax Detect
on page 28.)
If you answer a fax call at the external
telephone, you can make the machine
receive the fax by pressing Mono Start or
Colour Start and 2 to choose Receive.
Remote Deactivation Code 6
If you receive a voice call and the machine is
in Fax/Tel mode, it will start to sound the F/T
Ring (fast double-ring) after the initial ring
delay. If you pick up the call on an extension
telephone, you can turn the F/T Ring off by
pressing #51 (make sure you press this
between the rings).
If the machine answers a voice call and fast
double-rings for you to take over, you can
take the call at the external telephone by
pressing Tel/R.
Changing the remote codes 6
If you want to use Remote Activation, you
have to turn on the remote codes. The preset
Remote Activation Code is l 51. The preset
Remote Deactivation Code is #51. If you
want to, you can replace them with your own
codes.
a Press (FAX).
b Press Menu, 3, 1, 5.
c Press a or b to choose On (or Off).
Press OK.
d Enter the new Remote Activation Code.
Press OK.
e Enter the new Remote Deactivation
Code.
Press OK.
f Press Stop/Exit.
NOTE
• If you are always disconnected when
accessing your external TAD remotely, try
changing the Remote Activation Code and
Remote Deactivation Code to another
three-digit code using the numbers 0-9, l,
#.
• Remote Codes might not work with some
telephone systems.