Brother MFC-J2730DW - Page 303

Home > Fax > Receive a Fax > Receive Mode Settings > Choose the Correct Receive Mode
Choose the Correct Receive Mode
The factory setting of Receive Mode is “Fax Auto”. Your machine will automatically receive any faxes that are
sent to it. There are four Receive Modes of this machine as below.
Operation Display
Factory Setting Ring Delay
Fax Auto
Ring Delay: four times
Fax detection: On
Fax/Tel
Ring Delay: four times
External TAD
Fax Manual
>> MFC-J2330DW
>> MFC-J2730DW
MFC-J2330DW
1. Press
[Settings] > [All Settings] > [Fax] > [Setup Receive] > [Receive Mode].
2. Press a or b to display the [Fax Auto], [Fax/Tel], [External TAD], or [Manual] option, and then
press the option you want.
3. Press
.
MFC-J2730DW
1. Press [Settings] > [All Settings] > [Fax] > [Setup Receive] > [Receive Mode].
2. Press the [Fax Auto], [Fax/Tel], [External TAD] or [Fax Manual] option.
3. Press
.
Related Information
• Receive Mode Settings
• Remote Retrieval Commands
• Connect an External TAD
• Telephone and Fax problems
296