Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a
Wireless Network When the SSID is Not Broadcast
Configure Your Machine for a Wireless Network When the SSID is Not
Broadcast
>> MFC-J4340DW
>> MFC-J4440DW/MFC-J4540DW
MFC-J4340DW
Before configuring your machine, we recommend writing down your wireless network settings. You will need
this information before you continue with the configuration.
1. Check and write down the current wireless network settings.
Network Name (SSID)
Authentication Method Encryption Mode Network Key (Password)
Open System NONE -
WEP
Shared Key WEP
WPA/WPA2-PSK AES
TKIP
For example:
Network Name (SSID)
HELLO
Authentication Method Encryption Mode Network Key (Password)
WPA2-PSK AES 12345678
If your router uses WEP encryption, enter the key used as the first WEP key. Your Brother machine
supports the use of the first WEP key only.
2. Press .
3. Press a or b to select the [Find Wi-Fi Network] option, and then press OK.
4. When [Enable WLAN?] appears, press c.
The wireless setup wizard starts. To cancel, press d.
5. The machine will search for your network and display a list of available SSIDs. Press a or b to select the
[<New SSID>] option, and then press OK.
6. Enter the SSID name, and then press OK.
For more information about how to enter text, see Related Information.
7. Select the Authentication Method, and then press OK.
8. Do one of the following:
• If you selected the [Open System] option, press a or b to select the Encryption type [None] or [WEP],
and then press OK.
If you selected the [WEP] option for Encryption type, enter the WEP key, and then press OK.
• If you selected the [Shared Key] option, enter the WEP key, and then press OK.
295
To Next Page
Loading...
Need help?
General
