34
For Network Users
Reset the network settings to factory default
To restore all network settings of the internal Print/Scan server to the factory default, please follow the steps below:
a Make sure the machine is idle, then disconnect all the cables from the machine (except the power cord).
b Press Menu.
c Press a or b to choose Network.
Press OK.
d Press a or b to choose Network Reset.
Press OK.
e Press 1 to choose Yes.
f Press 1 to choose Yes.
g The machine will restart, re-connect the cables once this is complete.
Entering Text for Wireless Settings
Most number keys have three or four letters printed on them. The keys for 0, # and l do not have printed letters
because they are used for special characters.
By pressing the correct number key repeatedly, you can access the character you want.
For configuring wireless network settings
Inserting spaces
To enter a space in a name, press c twice.
Making corrections
If you entered a character incorrectly and want to change it, press d or c to move the cursor to the incorrect
character, and then press Clear. Enter the correct character. You can also back up and insert a character.
Repeating characters
If you need to enter a character that is on the same key as the character before, press c to move the cursor to the
right before you press the key again.
Special characters and symbols
Press l, # or 0 repeatedly until you see the special character or symbol you want.
Press
Key
One
time
Two
times
Three
times
Four
times
Five
times
Six
times
Seven
times
Eight
times
Nine
times
2 abcABC2ab
3 de fDEF3de
4 gh iGHI 4gh
5 jklJKL5jk
6 mn oMNO6mn
7 pqr sPQRS7
8 tuvTUV8tu
9 wxyzWXYZ9
Press l for
(space) ! ” # $ % & ’ ( ) + , - . /
Press # for : ; < = > ? @ [ ] ^ _
Press 0 for
0 \ { | }
˜
To Next Page
Loading...
Need help?
General
