Chapter 7
36
l Place the next page on the scanner
glass. Press OK to scan the page.
Repeat steps k and l until all the
pages have been scanned.
m Press 2 to finish scanning.
The machine starts printing.
DO NOT touch the printed page until it is
ejected the second time. The machine will
print the first side and eject the paper, and
then pull the paper in to print the second side.
If you get a paper jam, choose Advanced
and then press OK after step i, and then
choose one of the jam prevention settings:
2-sided1 or 2-sided2.
2-sided1 uses a longer print time for the
ink to dry.
2-sided2 uses a longer print time and
will also print in lighter colors.
Setting your changes as the
new default 7
You can save the settings for the copy
options you use most often—such as
Quality, Enlarge/Reduce, Density,
Page Layout, 2-sided Copy
1
and
Remove Background—by setting them as
the defaults.
1
MFC models only
These settings will remain until you change
them again.
a (MFC models)
Press (COPY).
b Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
c After changing the last setting, press
a or b to choose Set New Default.
Press OK.
d Press 1 or + to choose Yes.
e Press Stop/Exit.
Restoring all settings to the
factory settings 7
You can restore the copy settings that you
have changed—such as Quality,
Enlarge/Reduce, Density,
Page Layout, 2-sided Copy
1
and
Remove Background—to the factory
settings.
1
MFC models only
a (MFC models)
Press (COPY).
b Press a or b to choose
Factory Reset.
Press OK.
c Press 1 or + to choose Yes.
d Press Stop/Exit.
To Next Page
Loading...
Need help?
General
