5
h
Gently push the ink cartridge until it clicks. After
all the ink cartridges are installed close the ink
cartridge cover.
5
Check the print quality
a When the preparation process has finished, the
LCD shows Set Paper and Press Start.
Press Colour Start.
b Check the quality of the four colour blocks a
on the sheet. (black/yellow/cyan/magenta)
c If all lines are clear and visible, press 1 (Yes)
on the dial pad to finish the quality check and
go to step 6.
If you can see missing short lines, press 2 (No)
on the dial pad and follow the steps on the
LCD.
The machine will prepare the ink tube system for
printing. This process will take approximately four
minutes. Do not turn off the machine.
OK
Poor
1
To Next Page
Loading...
