Brother MFC-J6910DW - Photocapture Center Print Settings; How to Scan to a Memory Card or USB Flash Memory Drive

Chapter 9
62
PhotoCapture Center™
print settings
9
You can change the print settings
temporarily.
The machine returns to its default settings
after 3 minutes, or if the Mode Timer returns
the machine to Fax mode. (See Mode Timer
in chapter 1 of the Advanced User’s Guide.)
Note
You can save the print settings you use
most often by setting them as the default.
(See Setting your changes as a new
default in chapter 8 of the Advanced
User’s Guide.)
How to scan to a
memory card or USB
Flash memory drive
9
You can scan monochrome and color
documents onto a memory card or USB Flash
memory drive. Monochrome documents will
be stored in PDF (*.PDF) or TIFF (*.TIF) file
formats. Color documents may be stored in
PDF (*.PDF) or JPEG (*.JPG) file formats.
The factory setting is Color 200 dpi and
the default file format is PDF. The machine
automatically creates file names based on
the current date. (For details, see the Quick
Setup Guide.) For example, the fifth image
scanned on July 1, 2011 would be named
01071105.PDF. You can change the color
and quality.
a Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
IMPORTANT
DO NOT take out the memory card or
USB Flash memory drive while
PHOTO CAPTURE is blinking to avoid
damaging the card, USB Flash memory
drive or data stored on them.
Quality Selectable File
Format
Color 100 dpi JPEG / PDF
Color 200 dpi JPEG / PDF
Color 300 dpi JPEG / PDF
Color 600 dpi JPEG / PDF
B/W 100 dpi TIFF / PDF
B/W 200 dpi TIFF / PDF
B/W 300 dpi TIFF / PDF