Troubleshooting and Routine Maintenance
121
CAUTION
If you are not able to find the yellow
protective parts, DO NOT remove the ink
cartridges before shipping. It is essential
that the machine be shipped with either the
yellow protective parts or the ink cartridges
in position. Shipping without them will
cause damage to your machine and may
void your warranty.
d Unplug the machine from the telephone
wall jack and take the telephone line
cord out of the machine.
e Unplug the machine from the AC power
outlet.
f Lift the scanner cover from the front side
of the machine until it lock securely into
the open position. Then unplug the
interface cable from the machine, if it is
connected.
g Lift the scanner cover to release the
lock. Gently push the scanner cover
support down and close the scanner
cover.
h Wrap the machine in the bag and put it
in the original carton with the original
packing material.
i Pack the printed materials in the original
carton as shown below. Do not pack the
used ink cartridges in the carton.
Note
If you are returning your machine to
Brother as part of the Exchange Service,
pack only the machine. Keep all separate
parts and printed materials to use with
your ‘Exchange’ machine.
j Close the carton and tape it shut.
To Next Page
Loading...
Need help?
General
