Loading documents and paper
19
2
e Gently put the paper into the paper tray
print side down and top edge first.
Check that the paper is flat in the tray
and below the maximum paper
mark (1).
f Close the tray cover.
g Push the paper tray firmly back into the
machine.
Note
If you are using Auto Select, after
refilling the paper tray you should open
and close the scanner cover to reset the
machine.
Loading envelopes and post
cards 2
Loading envelopes 2
Use envelopes that weigh from 20 to 25 lb
(75 to 95 g/m
2
).
Some envelopes need margin settings to
be set in the application. Make sure you
do a test print first.
CAUTION
Do not use any of the following types of
envelopes, as they will cause paper feed
problems:
• If they are of a baggy construction.
• That are embossed (have raised writing
on them).
• That have clasps or staples.
• That are pre-printed on the inside.
Occasionally you may experience paper
feed problems caused by the thickness,
size and flap shape of the envelopes you
are using.
1
Glue Double flap
To Next Page
Loading...
Need help?
General
