Chapter 2
20
How to load envelopes and post cards2
a Before loading, press the corners and
sides of the envelopes or post cards to
make them as flat as possible.
Note
If the envelopes or post cards are
‘double-feeding,’ put one envelope or post
card in the paper tray at a time.
b Put the envelopes or post cards into the
paper tray with the address side down
and the leading edge in first as shown in
the illustration. Press and slide the
paper side guides (1) and paper length
guide (2) to fit the size of the envelopes
or post cards.
If you have problems when printing on
envelopes, try the following suggestions:
2
a Open the envelope flap.
b Make sure the open flap is either to the
side of the envelope or to the back edge
of the envelope when printing.
c Adjust the size and margin in your
application.
Removing small printouts from the
machine 2
When the machine ejects small paper onto
the output paper tray, you may not be able to
reach it. Make sure printing has finished, and
then pull the tray completely out of the
machine.
1
2
To Next Page
Loading...
Need help?
General
