IMPORTANT
• A distinct change in the product’s performance may indicate a need for service.
• DO NOT connect your product to an electrical socket controlled by wall switches or
automatic timers, or to the same circuit as a large appliance or other equipment that
requires a significant amount of electricity. It could disrupt the power supply. Disruption of
the power supply may also delete information from the product's memory, and repeated
cycling of the power supply can damage the product.
• We recommend that you use our genuine ink. Non-genuine ink may cause damage to the
print head. They may also result in differences in the colours or storage stability. (Not all
non-genuine ink cause these issues.)
• DO NOT put objects on top of the product. Doing so may cause the product to malfunction.
• If the product does not operate normally when the operating instructions are followed, adjust
only those controls that are covered by the operating instructions. Incorrect adjustment of
other controls may result in damage and will often require extensive work by a qualified
technician to restore the product to normal operation.
• DO NOT put any foreign objects into the ink tank. Doing this may cause the product to
malfunction.
Important Information for Australia
Important Safety Instructions
1. Read all of these instructions.
2. Save them for later reference.
3. Follow all warnings and instructions marked on the product.
4. Unplug this product from the wall socket before cleaning the outside of the product and the
scanner glass. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
5. Do not use this product near water.
6. Do not place this product on an unstable cart, stand, or table. The product may fall, causing
serious damage to the product.
7. Slots and openings in the cabinet and the back or bottom are provided for ventilation; to
ensure reliable operation of the product and to protect it from overheating, these openings
must not be blocked or covered. The openings should never be blocked by placing the
product on a bed, sofa, rug, or other similar surface. This product should never be placed
near or over a radiator or heater. This product should never be placed in a built-in installation
unless adequate ventilation is provided.
8. This product should be connected to an AC power source within the range indicated on the
rating label. Do not connect it to a DC power source. If you are not sure, contact a qualified
electrician.
12
To Next Page
Loading...
Need help?
General
