Brother P-touch 1750 - Attaching Labels

6
4
Insert the tape cassette firmly into the tape
compartment, making sure that the entire
back of the cassette touches the bottom of the
compartment.
☞
When inserting the tape cassette, make
sure that the inner ribbon does not
catch on the corner of the metal guide.
5
Close the compartment cover, then turn on
the machine if it is off.
6 Hold down f and press g once to
advance the tape and remove any slack.
7
Push down on the tape cutter lever to cut off
any excess tape.
STICK
A stick is enclosed in the right side of the tape compartment cover of the P-touch. Use this
stick when pasting laminated tape to an object.
1
Open the tape compartment cover.
2
Pull the tip of the stick towards you with your finger.
3
Hold the tip of the stick and pull up to remove it.
LAMINATED TAPE
The enclosed stick enables you to easily remove the backing from labels printed on lami-
nated tapes.
1
Hold the tape in your left hand, with the printed surface facing up, and hold the stick in
your right hand.
ATTACHING LABELS