Remove Battery for Replacement or Disposal
1. Turn the label printer off.
2. Open the Cassette Cover.
3. Remove the two screws from
the Battery Cover using a
flat-bladed screwdriver.
4. Remove the battery.
'RQRWGLVSRVHRIWKHEDttery with household waste.
There is a risk of environmental damage, explosion, or fire.
5. When reinserting the battery,
make sure the battery's contacts
are touching the contacts inside
the battery compartment.
6. Replace the Battery Cover,
reinsert the screws, and tighten
them with a flat-bladed
screwdriver.
7. Close the Cassette Cover.
Battery
Cover
'LVSRVHRIEDWWHULHVDWDQ
appropriate collection point.
Be sure to observe all
applicable local regulations.
:KHQVWRULQJRUGLVFDUGLQJ
a battery, cover the contacts
with cellophane tape
to prevent it from
short-circuiting.
DANGER
To Next Page
Loading...
