LABEL PRINTING
48
Tape Cutting Options
Tape Cutting
Setting Description Example
Margin L
Automatically cuts the tape after each label is
printed. The labels have a 0.94" (24 mm)
margin on the left and right ends.
Margin S
• When printing labels one at a time:
Automatically cuts a piece of blank tape
before printing the label, and then cuts the
tape after the label is printed.
• When printing several labels continuously:
Automatically cuts a piece of blank tape
before printing the first label, and then cuts
the tape after each label is printed.
• The labels have a 0.16" (4 mm) margin on
the left and right ends.
Chain
• When printing labels one at a time:
Automatically cuts a piece of blank tape
before printing the label, and then does not
cut the tape after the label is printed.
• When printing several labels continuously:
Automatically cuts a piece of blank tape
before printing the first label, and then cuts
the tape after each label is printed.
• The labels have a 0.16" (4 mm) margin on
the left and right ends.
• The tape is not fed and cut after the last
label is printed.
No Cut
• Use this setting to print a strip of labels with
no cuts in between.
• Using the "Cut" key will feed and cut the last
label printed.
ABC ABC
0.94"
(24 mm)
0.94"
(24 mm)
ABC ABC
0.16"
(4 mm)
0.16"
(4 mm)
0.89" (22.5 mm)
ABC ABC
0.16"
(4 mm)
0.16"
(4 mm)
0.89" (22.5 mm)
ABC ABC
1.04"
(26.5 mm)
0.31"
(8 mm)
• When using Fabric Iron-On Tapes, Extra Strength Adhesive Tapes or any other special tapes,
set "No Cut" to prevent the cutter from cutting the tape. Leave adequate space between labels
when creating and printing them, and then use scissors to cut the tape in the space between the
labels.
• The tape is not cut after the last label is printed when “Chain” or “No Cut” is set. Press the
key to feed and cut tape automatically, or cut the tape manually if you are using tape that
cannot be cut by the cutter.
To Next Page
Loading...
Need help?
General
