44
STAMP FUNCTION
The Stamp function allows you to quickly and easily create your own stamp stencil films for
customized stamps. After inserting a stamp film cassette, select this function to automatically
center the text and adjust the tape length and margins to a perfect format for the pre-inked
stamp film holders. Since the stamp holder is reusable, just make a new stamp stencil film and
replace the one in the holder.
To make a stamp:
1 Type in the text, and then insert a medium (3/4” (18-mm)-wide) or large (1” (24-mm)-
wide) stamp film cassette.
2 Hold down and press once. The message “STAMP FORMAT?” appears in the
display.
3 Press . The text is automatically formatted for the installed stamp: centered within
the preset message area with the tape length and margins automatically adjusted.
4 Press to cut the text out of the stamp stencil film.
5 After the stamp stencil film is cut off, remove the backing paper from the stamp stencil
film and affix it to the ink pad of a stamp film holder.
EXAMPLE
To cut a stamp:
1
Enter the text and insert a stamp film cassette in the tape compartment.
2 Hold down and press .
3 Press .
Stamp
Mirror
Stamp
FORMAT?
STAMP
Alt
Caps
Undl/Frm
Length
Wide
2:
1234 Main S _
1:
J. Smith
Alt
Caps
Undl/Frm
Length
Wide
To Next Page
Loading...
