37
3 Press r. The text is automatically formatted for the installed stamp: centered within
the preset message area with the tape length and margins automatically adjusted.
4 Press p to cut the text out of the stamp stencil film.
5 After the stamp stencil film is cut off, remove the backing paper from the stamp stencil
film and affix it to the ink pad of a stamp film holder.
☞ After setting the stamp format for a large (1” (24-mm)-wide) stamp cassette, be sure to
use the Clear function to return all format functions to their default settings
(TXT&FORMAT) before creating the next label.
EXAMPLE
To cut a stamp:
1
Enter the text and insert a stamp film cassette in the tape compartment.
2 Hold down c and press U.
3 Press r.
4 Press p to engrave the stamp stencil film, and then automatically cut off.
To affix a stamp:
5
Remove the stamp frame from around the stamp
film holder ink pad, one side at a time, then
remove the protective seal covering the ink pad
and the backing paper from the stamp stencil film.
6 With the glossy side of the stamp stencil film
upward, align one of its ends with the slit on the
side of the stamp film holder.
FORMAT?
STAMP
Caps
Alt
2:
1234 Main
1:
J Smith
Caps
Alt
_
1/1
COPIES
Caps
Alt
Tape end
Glossy side
Slit
To Next Page
Loading...
