41
To change the size setting:
1 While holding down c, press 2 once, and keep c held down to display the
current size setting.
2 While still holding down c, continue pressing 2 until the desired size setting is
displayed.
☞ The current size setting is shown by the size indicators at the top of the display.
3 Release c to apply the selected size setting to the entire text.
☞ With the AUTO setting selected and 3/4” (18-mm) or 1” (24-mm)-wide tape
installed, text consisting of just one line of only capital letters (and no accented
characters) will be printed with a character size of 52 points. If 1/2” (12-mm)-wide
tape is installed, the text will be printed with a character size of 29 points.
EXAMPLE
To select the 24 point size setting:
1
While holding down c, press 2 once,
and keep c held down.
2 While still holding down c, continue pressing
2 until 24 is displayed.
3 Release c.
AUTO
SIZE
Caps
Alt
24
SIZE
Caps
Alt
To Next Page
Loading...
