2006/05/31
CHAPTER 2 "PCL" - 7
1. COMMAND LIST
Control Codes 11
Escape sequences 12
Esc&k#G Line termination 12
Esc&s#C End-of-line wrap 13
EscY Display function mode 13
EscZ Display function mode 13
Environments 14
Job Control 15
Esc&l#A Page size 15
Esc&n# Media type selection 16
Esc&l#G Output tray 16
Esc&l#H Paper source 17
Esc&l#U Left long-edge offset registration 19
Esc&l#Z Top offset registration 19
Esc&l#S Simplex/duplex printing 20
Esc&a#G Paper side selection 20
Esc&l1T Job separation command 20
EscE Reset 20
EscCR FD Reset to factory default settings 21
EscCR!#R Reset to user settings 21
Escz Printer self test 21
Esc%-12345X Exit current emulation mode 21
EscCR## Change emulation mode 22
The Page 23
Esc&u#D Unit of measure 26
Esc&a#L Setting the left and right margins 26
Esc&a#M Setting the left and right margins 26
Esc9 Resetting the horizontal margins 27
Esc&l#E Setting the top margin 27
Esc&l#C Setting the vertical motion index (VMI) 28
Esc&k#H Setting the horizontal motion index (HMI) 28
Esc&l#D Setting line spacing 29
Esc&l#F Text length 29
Esc&l#P Page length 30
Esc&l#L Perforation skip 30
Esc&a#R Vertical cursor positioning -rows 31
Esc*p#Y Vertical cursor positioning - units 31
Esc&a#V Vertical cursor positioning - decipoints 31
Esc&a#C Horizontal cursor positioning - columns 32
Esc*p#X Horizontal cursor positioning - units 32
Esc&a#H Horizontal cursor positioning - decipoints 33
Esc&f#S Using the cursor position stack 33
Esc= Half line feed 34
Esc&l#O Logical page orientation 34
Esc&a#P Text direction 34
Using fonts 36
Esc(3@, Esc)3@ Selecting the default fonts 38
SI, SO Switching between the primary and secondary font 38
Esc*c#R Symbol set ID code command 41
Esc(f#W Define symbol set 41
Esc*c#S Symbol set control command 43
Esc(symbol set ID Select the symbol set 43
Esc(s#C, Esc)s#C Select the symbol set 44
Esc(s#P, Esc)s#P Selecting the type of character spacing 45
To Next Page
Loading...
Need help?
General
