Brother PJ-600 Series - Page 33

Brother PJ-600/700/800 Series Command Reference
30
© 2015 Brother Industries, Ltd. All Rights Reserved.
Name
Specify line feed of 1/6 inch
Syntax
ESC + 2
1B H + 32 H
Description
Specify line feed of 1/6 inch (6LPI).
The line feed becomes 1/6 inch.
After this command is specified, the page length in lines and bottom margin must
be specified again.
Name
Specify line feed of 1/8 inch
Syntax
ESC + 0
1B H + 30 H
Description
Specify line feed of 1/8 inch (8LPI).
The line feed becomes 1/8 inch.
After this command is specified, the page length in lines and bottom margin must
be specified again.
Name
Line feed at 8 LPI
Syntax
ESC + ~ + + + {n1}
1B H + 7E H + 2B H + {n1}
Description
Specify whether the line feed is “0.125"” or “0.12"” when the line feed is set to 1/8
inch.
You can use this command to allow extended ASCII graphic characters to touch
each other without creating a small vertical gap between the characters.
After this command is specified, the page length in lines and bottom margin must
be specified again.
Definition of {n1}
01 H(1) or 1F H(31) :0.120 inch Line feed
Other than those listed above :0.125 inch Line feed