Brother PJ-600 Series - Page 7

Brother PJ-600/700/800 Series Command Reference
4
© 2015 Brother Industries, Ltd. All Rights Reserved.
2. Printing commands
Repeat for each raster line in the print job.
Sequence
Command Name
Description/Example
－
Set left margin
Moves the cursor the specified distance from the left edge
of the printable area in the X direction.
1B H, 7E H, 24 H, {n1}, {n2}
－
1 Raster line data
transfer
Sends the raster line data.
To send 300 bytes of data:
1B H, 7E H, 2A H, 2C H, 01 H, FF H, FF H….
－
Multi-line feed
Terminates raster line data and feeds 1 or more lines.
1B H, 7E H, 4A H, {n1}
Note:
“Set left margin” and “1 Raster line data transfer” commands can be sent more than once per line
Example: The raster line data shown below can be sent with the following commands.
In addition, it is recommended that the “set left margin” command be used when a blank space extends
for 16 bytes or more.
Set left margin: 1BH, 7EH, 24H, 10H, 00H
Raster line data transfer: 1BH, 7EH, 2AH, 02H, 00H, 1FH, F8H
Set left margin: 1BH, 7EH, 24H, 30H, 00H
Raster line data transfer: 1BH, 7EH, 2AH, 01H, 00H, 3CH
Multi-line feed: 1BH, 7EH, 4AH, 01H
3. Print command
Specified at the end of the page.
Sequence
Command Name
Description/Example
－
Form feed
Specifies the end of a page.
１BH, 7EH, 0CH