Configuring your network printer
13
2
a Type http://printer_ip_address/ into your browser. (Where printer_ip_address is the IP
address or the print server.)
For example:
http://192.168.1.2/ (if the printer’s IP address is 192.168.1.2.)
If you have edited the hosts file on your computer or are using a Domain Name System, you can also enter
the DNS name of the print server. As the print server supports TCP/IP and NetBIOS, you can also enter
the NetBIOS name of the print server. The NetBIOS name can be seen on the Printer Settings Page. The
NetBIOS name assigned is the first 15 characters of the node name and by default it will appear as
“BRNxxxxxxxxxxxx” where “xxxxxxxxxxxx” is the Ethernet address.
b Click Network Configuration.
c Enter a user name and a password. The User Name is admin and the default Password is access.
d Click OK.
e You can now change the print server settings.
Printing the Printer Settings 2
The Printer Settings Page prints a report listing the network settings, etc. You can print the Printer Settings
Page using the Cut button of the printer.
Node name: Node name appears in the Printer Settings Page. The default Node name of the network card
in the printer is “BRNxxxxxxxxxxxx” where “xxxxxxxxxxxx” is the Ethernet address.
How to print the Printer Settings Page 2
a Make sure that the Roll is set and the front cover is closed.
To print the Printer Settings Page, we recommend to use 101.6 mm Roll.
b Turn on the printer.
c Press and hold the Cut button.
You can check the IP address, etc.
• To reset network setting and turn APIPA ON
Press the ON/OFF button to switch the machine OFF. Then, hold down the ON/OFF button for two
seconds. Continue holding down the ON/OFF button, and press the Cut button twice. All the network
settings will be reset.
• To reset network setting and turn APIPA OFF
Press the ON/OFF button to switch the machine OFF. Then, hold down the ON/OFF button for two
seconds. Continue holding down the ON/OFF button, and press the Cut button four times. All the network
settings will be reset.
To Next Page
Loading...
Need help?
General
