When replacing batteries or tape cassettes,
make sure the power is turned off.
This label maker requires six (6) AAA
alkaline batteries (included) or six (6) fully
charged Ni-MH batteries (not included).
Close the Cassette Cover and gently press
until it clicks into place.
If you prefer to use the optional AC Adapter
instead of using batteries:
1.
Insert the AC Adapter cord into the AC
2.
Insert the AC Adapter into a grounded AC
electrical outlet.
For backup memory, we recommend using both
batteries AND the optional AC Adapter, in the event
that one or the other power method fails.
AC Adapter
GETTING STARTED
Installing Power Supply and Tape Cassette
With the LCD facing down, open the Cassette
Cover by pressing the grooved tab and
pushing in the direction of the arrow, as
illustrated.
If a tape cassette is already installed, remove it
by pulling it straight up.
Insert the Tape Cassette following the
drawing marked inside the case. Gently
press the Cassette into the label maker until
it clicks into place.
Cassette is marked .
sure to remove the plastic before inserting the tape
cassette.
To Next Page
Loading...
Need help?
General
