MAINTENANCE PROCEDURES
mmo2007-009-064_a
PULL BULB A ND REPLAC E
Headlights Beam Aiming
Remove multifunction gauge, refer to
HEADLIGHTS BULB REPLACEMENT
.
Tu rn knob to adjust beam height.
mmo2007-009-023_a
TYPICAL
1. Knobs
Taillight Bulb R eplacement
1. Carefully pull taillight assembly by
both ends at the same time.
fmr2011-001-003
NOTICE
Plastic retaining pins
may break if taillight assembly is
forced sideways. Avoid sideways
movement when pulling taillight
out.
NOTICE
Do not pull taillight hous-
ing out too far to avoid damaging
wiring.
2. R emove lamp socket from taillight
assembly.
2.1 Turn socket counterclock-
wise.
2.2 Pull socket out.
3. Replace bulb.
4. Secure socket into taillight assem-
bly.
5. Push taillight assembly back into
place.
NOTE: Led taillight: leds cannot be re-
placed.
If led taillight is failed change taillight
assembly. Fasten new taillight by
screws.
114
______________
To Next Page
Loading...
