BRP Lynx 600R E-TEC 2018 - Recommended Oil; Injection Oil Level Verification

FUEL AND OIL
WARNING
– Always stop engine before refu-
eling. Open cap slowly.
– If a differential pressure condi-
tion is noticed (whistling sound
heard when loosening fuel tank
cap) have vehicle inspected
and/or repaired before further
operation.
– Fuel is flammable and explosive
under certain conditions.
– Never use an open flame to
check fuel level.
– Never smoke or allow flame or
spark in vicinity.
– Always work in a well-ventilated
area.
– Never top up the fuel tank be-
fore placing the vehicle in a
warm area. As temperature in-
creases, fuel expands and may
overflow.
– Always wipe off any fuel
spillage from the vehicle.
NOTE: Do not sit or lean on seat when
fuel tank cap is n ot properly installed.
Recommended Oil
600 HO E-TEC and 800R E-TEC
ENGINE
RECOMMENDED
INJECTION OIL
600 HO
E-TEC
800R E-TEC
XPS SYNTHETIC
2-STROKE OIL(F)
(P/N 619 590 106)
NOTICE
The engine of this snow-
mobile has been developed and val-
idated using the recomm ended BRP
XPS™ oil. BRP recommends the
use of its recomm ended XPS oil or
equivalent. Damages caused by oil
which is not suitab le for this oil in-
jected 2-stroke direct fuel injection
engine may not be covered by the
BRP limited warranty.
1200 4-TEC and 900 ACE
ENGINE
RECOMMENDED
ENGINE OIL
1200 4-TEC
900 ACE
XPS 4-STROKE
SYNTHETIC OIL (F)
(P/N 619 590 114)
NOTICE
The engine of this snow-
mobile has been developed and val-
idated using the BRP XPS™ Synthe-
tic 4-stroke oil. BRP recommends
the use of its XPS S ynthetic 4-stroke
or equivalent. Damages caused
by oil which is not suitable for this
4-stroke engine may not be covered
by the B RP limited warranty.
If the recommended oil is not avail-
able, use SAE 0W-40 synthetic-based
oil that meets or exceeds the require-
ments for API service classification
SM.
Injection Oil Level
Verification
The injection oil reservoir is located
behind the RH side panel. See
CON-
TROLS, INSTRUMENTS AND EQUIP-
MENT
for opening procedure.
Always maintain a sufficient amount of
recommended injection oil in the injec-
tion oil reservoir.
fmo2012-003-012_a
TYPICAL
1. Injection oil reservoir
2. Level marks (1/4, 1/2, 3/4)
70
______________