EasyManua.ls Logo

BRP Lynx 600R E-TEC 2018 - 24 Fuses; 25 Anchor Points

BRP Lynx 600R E-TEC 2018
164 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CONTROLS, INSTRUMENTS AND EQUIPMENT
CAUTION Running those
tracks at high speed in a trail, on
hard packed surfaces or ice put more
stress on the lugs, which tend to
heat up as a result. To avoid poten-
tial degradation or damage to the
track, reduce your speed, then mini-
mize the distance you ride on those
surfaces.
For general instructions on mainte-
nance of tracks, refer to the sections
TRACK
and
TRACK TENSION AND
ALIGNMENT
in the
MAINTENANCE
section of this guide.
24) Fuses
The electrical system is protected with
fuses, refer to
ELECTRICAL SYSTEM
for details.
The fuse box is located in the left side
of vehicle behind seat cover. To get ac-
cess to fuse box open lower side panel
and then remove s eat cover lower left
aside.
CAUTION Do not use a higher
rated fuse as this can cause severe
damage to electrical components
and/or be a potential fire.
WARNING
If fuse has burnt out, source of mal-
function should be determined
and corrected before restarting.
SeeanauthorizedLYNXdealerfor
servicing.
fmo2012-003-005
fmo2012-003-021
550 MODEL
25) Anchor Points
mmo2012-009-001_a
REAR OF VEHICLE
1. Anchor points
Two anchor points are pro
vided to se-
cure load in rear rack.
62
______________

Table of Contents

Related product manuals