BN1100 Revision: 0 Initial Issue: 21/08/2012
ATA 31-10-04
The accelerometer is intended to measure the vibration of the rotor for HUMS purposes on three axes: X, Y and Z. It consists of a
triaxial piezoelectric element and an electronic charge converter enclosed in a hermetic housing. The output provides a voltage
signal proportional to the acceleration for each axis. It is powered by a constant current line drive supply on the same wire as the
output signal on each axis.
Fig. 3 Accelerometer 4524-W-001
Fig. 4 Dimensions : All dimensions in millimeters
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
