BRUEL & KJAER Mediator 2238 - Page 16

Chapter 1 – Introduction
Measurement Parameters
1–10
Brüel & Kjær2238 Mediator
User Manual
Note 1: It is not possible to select the same frequency weight-
ing (A, C or L) for both detectors when they are both set to
RMS.
Note 2: If the Aux 1 or Aux 2 socket is used for input, the
signal(s) can be displayed and stored.
Detector 2 — Peak Parameters
L
Xpk
LCpk Instantaneous peak level “C” or
“Lin.”
–
L
Xpkmax
LCpkmax Max. Peak level detected
during the measurement
“C” or
“Lin.”
–
Number of
Peaks
#cPeaks Counts the number of
seconds where a speci-
fied peak level is
exceeded during a meas-
urement
“C” or
“Lin.”
–
Table 1.1 (cont.) Parameters available with the Enhanced module