26 Icon System Manual T02985_02_03
Safety (English)
3.4 General Safety Information
The ICON product is subject to the safety demands given by the low voltage directive
(LVD 2014/35/EEC). General electric safety is proven by the application of the safety
requirements for electrical equipment for measurement, control and laboratory use of the
EN 61010-1 and EN 61010-2-081.
According to these regulations, no part accessible under the condition of a single electrical
fault is hazardous to human life. In terms of electromagnetic conformity, the requirements
are cited in the regulations of EN 61326-1.
Risk of death by electrocution.
All electronics cabinet doors are safely screwed in place. Removal of cladding or
exchanging any component should only be performed by authorized and
appropriately trained personnel. The relevant unit or the entire system must be
switched off. Some components are charged with very high voltages. Inappropriate
action, or non-observance of warning signs, may result in fatal accidents. Special
care has to be taken when room climate is out of specification and condense water
appears.
Risk of injury or death.
Visually inspect the system power mains cable for damage on a regular basis.
In case of damage immediately replace it.
3.5 Mechanical Injury
The hazard of falling down is related particular to the unfavorable routing of cables/ tubes
To Next Page
Loading...
