66 Icon System Manual T02985_02_03
MRI System Operation
5.2.2 Basic Workflow
Switch
on the console and afterwards switch the scanner on and start ParaVision.
Before you start scanning, complete the following preparation steps:
1.
Choose the appropriate animal bed and RF Coil according to your desired
application and mount it to the basic holder.
2. Place the animal or sample on the animal bed.
3.
Position the setup in the magnet.
Preparation
Position setup in the
magnet
Mount animal bed
Position animal/
sample on the bed
Figure 5.1: Prepare and run scans: Preparation
The generalized ParaVision workflow includes the four steps shown below:
To Next Page
Loading...
