5.
Enter the desired value for the air humidity using
the [Humidity] rocker switch (
Ä
Chapter 5.4 “Set-
ting the desired air humidity” on page 39) on the
remote control.
6.
Then enter the desired fan speed using the [Fan]
rocker switch (
Ä
Chapter 5.5 “Regulating the fan”
on page 39).
7.
Wait for 10 seconds until the saving process is
completed.
ð
The display read-out jumps back to the actual
air humidity value. The humidifier is now ready
for operation.
The fan of the humidifier starts, if the set target
value is above the actual value.
4.4
Coding the wireless sensor system
Danger to life from electrical current!
– Prior to opening the device disconnect the
power plug.
Risk of imminent fatal injury from electric shock
due to contact with live parts.
The humidifier and the wireless sensor system are dedi-
cated to each other via coding. The devices are shipped
from the factory already encoded. When two or more
devices that are in close proximity to one another (0–30
meters, 0–98 feet), a different coding may be neces-
sary.
When several devices are operated in one room, the
following options are available:
n Several devices are operated via one sensor. For
this, all devices should have the same coding.
n Each device is controlled via a separate sensor. For
this, all devices have to be coded differently.
L DANGER
Commissioning
2013-11-04Evaporation Humidifier B500 Professional32
To Next Page
Loading...
