3.
Lift center piece from the water tank and place on
the side surface (Fig. 64).
ð
The UV degermination system is located below
the center plate next to the pump (Fig. 65/1).
4.
Check stainless steel pipe for damage and con-
tamination. If required, remove contamination
using a cloth and lime remover.
5.
Take the pump hoses off the stainless steel pipe
and clean using the cleaning brush. In case of
severe contamination or wear, replace pump
hoses.
Fig. 64: Remove center piece
Fig. 65: UV degermination
system
Fig. 66: Clean pump hoses
Accessories
2013-11-04 Evaporation Humidifier B500 Professional 73
To Next Page
Loading...
