Attaching Rail Cloth
Attach rail cloth:
Corner Pocket
1. Place cloth on rail with the back side down. The cloth should have equal amount of overhang at both ends of rail
and extend 1/2” over the featherstrip groove on the cushion side as shown. Except for approximately 3” at end of
rail, tap featherstrip down with a tapping block and hammer, starting at center of rail. Stretch cloth tightly toward
each end of rail and tap featherstrip down.
Item Description Qty.
1 Rail 1
2 Bed Cloth 1
3 Featherstrip 1
2. At each end of rail, pull the cloth toward the rubber cushion an additional 3/4”. Then tap remainder of featherstrip
down.
Item Description Qty.
1 Rail 1
2 Bed Cloth 1
3 Featherstrip 1
Page 15 of 24
To Next Page
Loading...
