1
TABLE OF CONTENTS
PAGE
SAFETY CONSIDERATIONS 1................................
INTRODUCTION 2..........................................
INSTALLATION CONSIDERATIONS 3..........................
INSTALLATION 6...........................................
SYSTEM START- UP AND CHECKOUT 39......................
OPERATIONAL INFORMATION 42............................
TROUBLESHOOTING 46.....................................
WIRING DIAGRAMS 50......................................
THERMOSTAT CONFIGURATION RECORD 59..................
SAFETY CONSIDERATIONS
Read and follow manufacturer instructions carefully. Follow all local electrical
codes during installation. All wiring must conform to local and national electrical
codes. Improper wiring or installation may damage AC/HP Control.
Recognize safety information. This is the safety - alert symbol
. When you see
this symbol on the equipment and in the instruction manual, be alert to the potential
for personal injury.
Understand the signal words DANGER, WARNING,andCAUTION.These
words are used with the safety - alert symbol. DANGER identifies the most serious
hazards which will result in severe personal injury or d eath. WARNING signifies a
hazard which could result in personal injury or death. CAUTION is used to identify
unsafe practices which may result in minor personal injury or product and property
damage. NOTE is used to highlight suggestions which will result in enhanced
installation, reliability, or operation.
To Next Page
Loading...
Need help?
General
