Bryston B100 User Manual

TABLE OF CONTENTS
 Page
• INTRODUCTION 1
• SETUP 1
• CONNECTIONS 1
• INPUTS&OUTPUTS 1-2
• LEDSTATUSINDICATORS...................................................................... 2
• REMOTEPOWERCONTROL.................................................................. 3
• PROGRAMMINGTHE12VTRIGGER 3
• HAND-HELDIRREMOTECONTROL..................................................... 4
• PROGRAMMINGTHEIRREMOTECONTROL 4
• SENDINGCODEStotheB100viatheIRREMOTECONTROL  4
• WIREDRS232REMOTECONTROL 4
• PASS-THROUGHMODE.......................................................................... 5
• DIGITAL-TO-ANALOGCONVERTEROPTION 5
• MOVING-MAGNETPHONOSTAGEOPTION 5
• SPECIFICATIONS..................................................................................... 6
• FRONT&REARPANELDETAILS.......................................................... 7
• EXTERNALDIMENSIONS&RECOMMENDEDCLEARANCEENVELOPE ............ 8
B100 INTEGRATEDAMPLIFIER

Bryston B100 Specifications

General

Power Output	100W per channel into 8Ω
Signal to Noise Ratio	>110dB
Input Sensitivity	500mV for full output
Dimensions	17" W x 4.5" H x 15" D
Inputs	1 XLR
Outputs	1x speaker binding posts
Phono Option	Available
DAC Option	Available
Total Harmonic Distortion	<0.005% 20Hz-20kHz at 100 watts