Bryston B100 - B100 Technical Specifications; Power Amplifier and Preamplifier Specs; General Specifications and Dimensions

POWER AMPLIFIER SECTION:
PowerOutput: 100wattsperchannelinto8Ω
 180wattsperchannelinto4Ω
InputImpedance: 50Kohmssingleended
Sensitivity: 1v=100Wattsinto8ohms(gain=28.28or29dB)
Distortion: THD+noise:<0.005%20Hzto20kHzat100wattsinto8ohms,
IMD: <0.010%60Hz+7KHzmixed4:1
Noise: >108dBbelowratedoutput(with20Hzto22KHzbandpassfilter)
SlewRate: >60voltspermicrosecond
PowerBandwidth: <1Hztoover100kHz
DampingFactor: Over500at20Hz,ref.8ohms
Powerconsumption: idle30va,maximumpower600va
Heatload: idle100btu/hr.,maxpower288btu/hr
PREAMPLIFIER SECTION:
Frequencyresponse: 20Hzto20KHz,±.05dB
IMDorTHD: <.007%
HighLevelSensitivity: 500mV
Noise: 100dB@20Hzto20KHz (ref:1Vinput)
GENERAL:
Dimensions: 17”or19”wideX4.55”highX14”deep
 (433or483mmX116mmX353mm)
Weight: approx.30lbs(13.6kg.)
B100 SPECIFICATIONS
B100 INTEGRATEDAMPLIFIER