If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
22
Auto end
If auto end is set to On you
can end a call by placing the
handset back in the base. If
auto end is set to Off, you’ll
need to press
to end the
call. Auto end On is the default
setting. See page 61.
Out of range warning
When the handset is out of
range of the base, the display
will show Searching for base…,
the backlight will turn up to
100% to indicate the alert
message and you will hear a
warning tone. After 60 seconds
the display will show No base
link. Check base. You need to
move back within range of the
base station.
If you move out of range when
you’re on a call, you’ll lose your
connection. The handset will
automatically re-connect to
the base when you move back
within range.
To switch the handset off
1. Press and hold
until the handset turns off.
To switch the handset on
1. Press and hold
until the handset turns on.
Make an external call
1. Press
.
2. When you hear the dial tone, enter the number.
Preparatory dialling
1. Enter the number first. If you make a mistake select
Clear by pressing the Right option button to delete
the last digit.
2. Press
to dial.
End a call
1. Press
. Or, press to end the call and add
the caller’s number to the blocked numbers list, see
page 30 (only blocks if the number is available and if
you’ve subscribed to a Caller Display service).
Call timer
Your handset will automatically time your outgoing
and incoming calls. The handset shows the length of
time both during and for a few seconds after your call.
Using the phone
To Next Page
Loading...
