If you experience any problems, please visit
15
Using the phone
If your telephone is connected to a switchboard you may need to change the
message waiting switch setting on the base of the phone. It is pre-set to MW3
which is for an SX2000 switch. MW1 and MW2 positions are for when the
telephone is connected to an ISDX switch. If the switch is moved to MW2 and the
message waiting indicator stays on permanently, use MW1.
To access your messages, either:
1. Lift the handset (or press
or )and dial
.
Or
1. Press
. Display shows BT Services.
2. Press
. Display shows BT Answer 1571.
3. Press
and lift the handset or press or .
If in doubt, please refer to your PBX instructions/manager for the correct
procedure to access this service.
The Recall
button is used to access a range of switchboard services, for
example, to transfer calls and with some BT Calling Features.
To Next Page
Loading...
